Installing the Upper System Board, Backup Battery and RTC Battery
To install the computer's upper system board, backup battery and RTC battery, follow the
steps below and refer to Figures 4-9 and 4-10.
1.
Connect the FL inverter board cable to PJ204 (Figure 4-10).
2.
Place the upper system board on the lower system board (Figure 4-10).
3.
Align the connector (PJ1), then press the upper system board to connect them.
NOTE: Make sure the upper system board is not attached to the lower system board
components. Refer to Figure 4-11.
4.
Secure the six M2.5x4 screws on the upper system board (Figure 4-10).
5.
Reflect the insulator away, then connect the RTC battery cable to PJ403 (Figure 4-
9).
6.
Connect the backup battery cable to PJ203 (Figure 4-9) and replace the protective
tape.
7.
Connect the battery release switch cable to PJ10 (Figure 4-9).
8.
Install the back cover, HDD, optional PCMCIA card, optional memory card, and
battery pack as described in sections 4.2, 4.3, 4.4, 4.5 and 4.6.
4-18
Figure 4-11 Installing the Upper System Board
T200, T200CS