Procedure 2 Message Check - Toshiba T200 User Manual

Procedure 2 Message Check
When the HDD does not function properly, some of the following error messages may appear
on the display. Start with Check 1 below and perform other checks as instructed.
Check 1 If any of the following messages appear, perform Check 2. If the following mes-
sages do not appear, perform Check 4:
HDC ERROR
(After 5 seconds this message will disappear.)
HDD #0 ERROR
(After 5 seconds this message will disappear.)
HDD #1 ERROR
(After 5 seconds this message will disappear.)
Check 2 If either of the following messages appears, perform Procedure 3. If the following
messages do not appear, perform Check 3.
Insert system disk in drive
Press any key when ready .....
Non-System disk or disk error
Replace and press any key
Check 3 Using the Toshiba MS-DOS system disk, install a system program on the hard disk
using the SYS command.
If the following message appears on the display, the system program has been
transferred to the HDD. Restart the computer. If the error message still appears,
perform Check 4.
System transferred
Check 4 The HDD is connected to the system board. Disassemble the computer as de-
scribed in Chapter 4, Replacement Procedures. If the HDD is disconnected, re-
attach it to the system board and return to Procedure 1. If the HDD is firmly
connected to the system board, perform Procedure 3.
2-22
or
or
or
T200/T200CS