Toshiba T200 User Manual page 55

7. Move the highlight bar to the desired option from the subtest menu and tap or
press Enter . The following message will appear:
TEST LOOP : YES
Selecting YES increases the pass counter by one each time the test cycle ends and
restarts.
Selecting NO returns the sub-test menu to the main menu after the test is com-
plete.
8. After making the Test Loop selection, the following message will appear:
ERROR STOP : YES
Selecting YES stops the test program when an error is found and displays the
operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME
These three selections have the following functions:
1: Terminates the test program and exits to the subtest menu.
2: Continues the test.
3: Restarts the test from the beginning.
Selecting NO keeps the test running even if an error is found.
Move the highlight bar to the desired option and tap or press Enter .
9.
Table 3-1 in Section 3.3 describes the function of each test on the subtest menu.
Table 3-3 in Section 3.16 describes the error codes and error status for each error.
T200, T200CS
NO
NO
[[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
3-5