Barcode Unit Specifications - Sekonic SR-6500 HYBRID Operating Manual

Barcode unit / V • barcode unit / H ■ Barcode unit specifications

■ Barcode unit specifications

Barcode unit / V (vertical feeding)
Reading direction
Codes
Reading area
Number of digits to be read Maximum 32 digits (total number of digits to be read is 150 or less)
Number of labels to be read Maximum 10 (1 sheet)
Label interval
Barcode printing specifications
Reading side
Directions to adjust reading positions
-90-
Vertical feeding (bars are parallel to sheet feeding direction)
JAN/EAN/UPC (module 0.33 mm,0.8 times~ 2 times)
NW-7
CODE-39
CODE-128
ITF( (Interleaved Two of Five)
Industrial 2 of 5
COOP 2 of 5
* The unit can be set to read up to four kinds of codes.
Sheet feeding direction : It depends on sheet size setting.
Refer to Barcode readable area in page 72.
Paper width direction : ±30mm of 50~200 from sheet edge(timing mark side).
(For CODE-128, a maximum of 64 digits if the starting character is CODE-C)
15mm or more
• Length 60mm or less X height 10mm or more
(For narrow bars with widths of 0.19mm or less,
use coated labels less than 40mm long ※ 1)
* Barcode length requires a quiet zone (margin) more than 2.54mm on both
sides or 10 times the width of the narrow bar, whichever is bigger.
• PCS: 0.7 or more (light-source wavelength: 633nm)
• Bar width (narrow bar) 0.125-1mm
* Bar:space ratio = 1:0.85-1.15
* Recommended N:W ratio = 1:2.5
* There should not be any bleeding, chipping, blank areas, etc.
• Skew: ±5 degrees or less from the standard paper feeding edge.
* If narrow bar width is 0.19mm or less, ±2 degrees or less.
Read the top surface of a sheet as it is fed
Paper width direction: manually adjust the head position
Sheet feeding direction:
"Specifying reading start position mode"
Use command to specify reading starting position from
the front edge of a sheet and reading width for number
of barcodes.
"Whole area reading mode"
Entire area of a sheet can be read.
(Barcodes in all areas of the sheet-feeding direction
can be read.)
※1 entire thickness of label sticking section is 0.25mm or less
Label must not be floated and come off.