Sekonic SR-6500 HYBRID Operating Manual page 102

(3) Operation errors
Error
Hopper stops
Drawing out error
Timing mark error
Setting error
Overflow of the Image
memory
Black level error
Reading start detection
sensor stain error
Error displays and countermeasures
Explanation Code
Interlock on the side of the
R1
paper-feeding roller operated.
Sheet was pulled out after it
R2
was fed.
Only three or fewer timing
marks were detected on the
front side of the read sheet.
R4
Only three or fewer timing
marks were detected on the
back side of the read sheet.
When reading front side marks
using a timing control type, the
next timing mark is detected
within the are a s e t b y the
control multiple number.
R5
When reading back side marks
using a timing control type, the
next timing mark is detected
within the are a s e t b y the
control multiple number.
Out of specification(long length)
R6
sheet fed in the device.
There is light colored stain on
the front side reading unit.
S2
There is light colored stain on
the back side reading unit.
There is stain on reading start
S3
detection sensor.
Procedures for Resolving and Clearing Errors
• Release the interlock switch.
• Press the CLEAR switch
(or execute the clear error command).
• Place sheets back on the hopper.
• Press the CLEAR switch
(or execute the clear error command).
• Check the orientation of the
sheets.
• Check the specifications of the
sheets.
• Press the CLEAR switch
(or execute the clear error command).
• Set a reading type and a control
multiple number according to
specifications of the sheets.
• Check the specifications of the
sheets.
• Press the CLEAR switch
(or execute the clear error command).
• Press CLEAR switch
• Send error clear command
• Check the reader unit for dirt
and other contamination and
clean as necessary.
• Press the CLEAR switch
(or execute the clear error command).
• After cleaning the sensor, turn
the power back on.
-101-