Sekonic SR-6500 HYBRID Operating Manual page 13

Precautions For Use
(4) This device is designed to deferred type.Do not give it a strong vibration
and shock etc.
(5) Allow an interval of at least 5 seconds between turning the power switch
on and off.
(6) Do not insert objects other than paper sheets (such as paper clips,
staples, etc.).
(7) Do not apply force that deforms paper while it is being loaded.
(8) Since the paper reading part is equipped with an optical lens, never insert
a screwdriver or other such objects. (Otherwise, reading may be disabled.)
If paper feeding is disabled due to dust or the like in the paper feeder,
open the top cover to remove it. ( S e e "Cleaning" P.80)
(9) If the roller becomes soiled with powder from paper or pencil lead, the
roller and the paper may slip. In order to prevent slippage, clean the roller
at proper intervals. ( S e e "Cleaning" P.80)
(10) If the exterior of the device is soiled, lightly wipe with a soft cloth wetted
with water or a neutral detergent. Note that wiping with a cloth wetted
with volatile chemicals like benzene or paint thinner may cause deforma-
tion or discoloring.
(11) Do not apply strong loads to the tray, as it may bend or break.
(12) The Aligning roller has a magnet.
Do not place it to the following materials, otherwise the data stored may
be damaged or may malfunction.
Cash card, floppy disc, other magnetic cards, TV Set, CRT display or
LCD, Watch, and other apparatus sensitive to magnetic fields.
(13) Make sure to observe the following points when you handle the device
and USB cables. Otherwise, mechanical failure or damage may be caused.
* Do not forcibly pull or bend the USB cable.
* Always hold the plug when you insert or pull out the USB cable. Never
apply excessive force to the cable.
* When installing/moving the device or a PC, do not apply excessive power
to the cord or plug of the USB cable.
-12-