Setting Density Balance - Sekonic SR-6500 HYBRID Operating Manual

Data reading settings ■ Setting density balance

■ Setting density balance

You can set the density balance level when using the SR-9000 operating mode.
Density balance can be set so that when marks are read, marks lighter than the set density
balance will be ignored, and marks darker than the set density balance will be detected.
Density balance can be set from 1 to 15.
1.
MENU
Press the
2.
UP
Use the and
and press the
3.
UP
Use the and
and press the
*
(" " mark flashes in the first column of the first line on the LCD.)
4.
UP
Use the and
5.
FEED/ENTER
Press the
(The flashing "
6.
Keep pressing the
or press the
Note)
See the operating manual of each type in regard to density balance.
-40-
switch to enter the menu mode.
DOWN
switches to select the following parameters,
FEED/ENTER
switch.
DOWN
switches to select [Density Balance] setting,
FEED/ENTER
switch.
DOWN
switches to set the value.
switch to save the setting value into memory.
*
" mark disappears from the LCD.)
CLEAR/EXIT
switch until it returns to normal mode,
MENU
switch to return to normal mode.
Density balance
setting values
1 - 15