Connecting To A Computer; Usb - Sekonic SR-6500 HYBRID Operating Manual

Operation ■ Connecting to a computer

■ Connecting to a computer

This device is equipped with USB and RS-232C interfaces. When connecting the OMR,
the connection with USB in order to show the performance of this device sufficiently is
recommended. When using USB connection, use the USB driver inside CR-ROM that came
with this device.
When replacing the OMR SR-9000 series with this device, you can use the RS-232C
interface. ※ 1
When using the RS-232C interface, set the same communication setting on this device and
the computer.
Set the computer communication setting by checking your computer or software manuals.
※ 1 ) There are times when it does not operate normally due to the specification of SR-9000.
See the following pages to set the communication setting for this device.

USB

Operating mode → select SR-6500 mode .................. P.19
Interface setting (device ID setting) ............................... P.20
• See P.19 and later when using USB.
RS-232C
Operating mode → select SR-9000 mode .................. P.21
Interface settings
Setting baud rate ..................................................... P.22
Setting cheracter bit length ...................................... P.22
Setting parity ............................................................ P.23
Setting stop bit ......................................................... P.24
Setting flow control .................................................. P.24
Setting character code ............................................. P.25
• See P.21 and later when using RS-232C.
Note)
*
Responding time of resetting command(CAN command) which is
stated in the operating manual of SR-9000 series
Time after received resetting command(CAN command) ,it return ACK
code is maximum approximately 5 to 6 seconds.
*
As for the details of commands of SR-9000 mode please see the
operating manual of SR-9000
-18-