Philips DVDR615 Service Manual page 57

http://www.jdwxzlw.com/?fromuser=华盛维修
123402
Example DS:> 1234
Enter the new Download Table Filename (Currently equals DVDR2001.001)
Enter a filename:
>
The Download Table Filename will be set to: DVDR2001.001.
Is that correct? ([Y/N]):
123402: Setting the filename was aborted by the user.
Error @
DS:> 1234
Enter the new Download Table Filename (Currently equals DVDR2001.001)
Enter a filename:
>DVDR2002.001
The Download Table Filename will be set to: DVDR2002.001. Is that correct? ([Y/N]):Y
123400:
Test OK @
Nucleus Name DS_SYS_IicWriteRead
Nucleus Number 1235
Description Perform an IIC write-read action on the digital board
Technical -
-
-
-
Execution Time Less than 1 second
User Input The user inputs the Bus ID, Slave Address, number of bytes to read, number of bytes
to write and the bytes to be written
<NucNr><BusId><SlaveAddr><ReadLen><WriteLen><WrByte0...WrByteN>
Max number of bytes to write: 255
Max number of bytes to read: 255
Error Number
123500
123501
123502
123503
123504
123505
123506
123507
123508
123509
123510
123511
Example DS:> 1235 0 0xa0 0xf 1 0
0x0000: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
0x0008:0x00 0x00 0x00 0x00 0x00 0x00 0x00
121000:
Test OK @
Nucleus Name DS_SYS_UartSetup
Nucleus Number 1236
Description Set up a configuration for the selected UART
Technical -
-
Execution Time Less than 1 second
家电维修资料网，免费下载各种维修资料
Diagnostic Software
Setting the filename was aborted by the user.
Determine bus ID, slave address, number of bytes to be written and the byte
array of data from the user input
Initialise IIC
Write the data to the IIC slave
Read the data from the IIC slave
Description
Writing data to and reading data from the IIC slave
succeeded
The IIC bus was not accessible
There was a bus timeout reading the device
The IIC acknowledge was not received
Unable to initialise IIC bus
The communication with the device failed
Unknown IIC bus error received
Decoding bus ID unsigned value failed
Decoding slave address unsigned value failed
Decoding number of bytes unsigned value failed
Bus ID out of range
Number of bytes out of range
Parse user input
Use MIS_UART_Setup to setup the selected UART with the requested
parameters
DVDR615/69 5. EN 57