Philips DVDR615 Service Manual page 37

http://www.jdwxzlw.com/?fromuser=华盛维修
Error Number
91000
91001
91002
91003
91004
91005
91006
Example (AV2) DS:> 910
Momentary errors (Byte 1 - Byte 7) : 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Cumulative errors (Byte 1 - Byte 7) : 0x00 0x00 0x00 0x20 0x00 0x00 0x00
Fatal errors (Oldest - Youngest)
091000:
Test OK @
Example (AV3) DS:> 910
Momentary errors (0-9): 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Cumulative errors (1-9) : 0x00 0x80 0x20 0x00 0x00 0x00 0x00 0x00 0x00
Software fatal assert : 799 engineproxy.cpp
091000:
Test OK @
Nucleus Name DS_BE_ErrorLogReset
Nucleus Number 911
Description Reset the error log in the basic engine
Technical -
-
-
command
Execution Time 2 seconds
User Input None
Error Number
91100
91101
91102
91103
91104
91105
Example DS:> 911
091100:
Test OK @
Nucleus Name DS_BE_JitterOptimise
Nucleus Number 912
Description Perform jitter optimisation:
A formatted DVD must be loaded into the engine before executing this nucleus
Technical -
-
-
-
0x80 is received
-
play the average jitter and bler values
Execution Time Approximately 20 seconds
User Input none
家电维修资料网，免费下载各种维修资料
Diagnostic Software
Description
The command executed successfully
There was a time-out while communicating
The Basic Engine returned an unexpected result
The BE returned an error code
No acknowledge received from BE
Communicating with the Basic Engine failed
The BE returned no info
: 0x00 0x00 0x00 0x00 0x00
Check if an AV2 or AV3 is connected
In case of an AV2
- Send theS2B RESET_STATISTICAL_INFO command
- Send the S2B POWER_DOWN command
- Toggle the reset pin of the I2S interface
In case of an AV3 Send the transparent BIT engine RESET_STATISTICAL_INFO
Description
The command executed successfully
There was a time-out while communicating
The Basic Engine returned an unexpected result
The BE returned an error code
No acknowledge received from BE
Communicating with the Basic Engine failed
Check if an AV2 or AV3 is connected
Send the TRAY_IN command
Send the READ_TOC command
In case of an AV2
- Send the JITTER_COMMAND command with parameter 0x00 0x00
- Send the JITTER_COMMAND command with parameter 0x00 0x01
- Send the JITTER_COMMAND command with parameter 0x00 0x02 until offset
In case of an AV3 Send the MEASURE_JITTER_BLER_PPN command and dis-
DVDR615/69 5. EN 37