Philips DVDR615 Service Manual page 40

http://www.jdwxzlw.com/?fromuser=华盛维修
EN 40 5. DVDR615/69
Example(AV2)
Example (AV3)
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
家电维修资料网，免费下载各种维修资料
Diagnostic Software
DS:> 920
092000:
Tilt sensor bathtub: (71,-12,145)(68,-12,135)(62,-10,120)(56,-92,97)(50,-75,86)
(44,-59,80)(41,-52,80)(35,-37,86)(29,-22,86)
(23,-7,92)(17,8,111)(11,23,135)(8,31,138)(5,39,158)
Test OK @
DS:> 920
092010: Tilt function is not supported by the engine
Error @
DS_BE_CheckDisc
921
Check whether there is a disc inside the BE
- Send the TRAY_IN command
- Send the READ_TOC command
- Display the Disc type info
- If Disc type is a DVD+R(W), then read ADIP info.
- Display manufacturer and media type.
Approximately 10 seconds
None
Number Description
92100 There was a disc inside the set
92101 Unable to load the tray
92102 Error received from BE
DS:> 921
092100:
Disc type: DVD+RW disc
Disc manufacturer id: PHILIPS
Media type id: 010
Test OK @
DS:> 921
090500:
Disc type: None
Test OK @
DS:> 921
092100:
Disc type: DVD+R disc
Disc manufacturer id: RICOHJPN
Media type id: R00
Test OK @
DS_BE_SledgeMotor
922
Send the sledge to its home position, then to the middle of the disc, and then to the
end.
- Send the PCS_COMMAND command with parameter 0x03 0x00
- Send the PCS_COMMAND command with parameter 0x02 0x00
- Send the PCS_COMMAND command with parameter 0x00 0x01
- Send the PCS_JUMP_SLEGE_STEPS command for 3 times
- Send the PCS_COMMAND command with parameter 0x00 0x00
4 seconds on AV2
11 seconds on AV3
None
Number Description
92200 The command executed successfully
92201 There was a time-out while communicating
92202 The Basic Engine returned an unexpected result
92203 The BE returned an error code
92204 No acknowledge received from BE
92205 Communicating with the Basic Engine failed
92206 Unable to enter service mode
DS:> 922
092200:
Test OK @