Philips DVDR615 Service Manual page 16

http://www.jdwxzlw.com/?fromuser=华盛维修
EN 16 5. DVDR615/69
Command overview Digital Board
Below you will find an overview of the nuclei, their numbers,
and their error codes. This overview is preliminary and subject
to modifications.
Note: AV3 in the overview includes also the AV3.5 drive.
CODEC HOST CONTROLLER (CHR)
Nucleus Name DS_CHR_DevTypeGet
Nucleus Number 100
Description Retrieves the device id, the module ids and revisions of the Codec and returns them to the
stdout port.
Technical -
Determine the codec id by means of comparing version ids of the modules.-
Read the module-id register of every module and display it to the user.
Execution Time Less than 1 second.
User Input None
Error Number
10000
10001
Example DS:> 100
010000:
Device ID 7100
Codec ID PNX7100_C
F-BCU (0x0102) 1.0
SIF
(0x010a) 1.0
DEBUG (0x0116) 0.0
UART2 (0x0107) 0.1
I2C1 (0x0105) 0.1
DISP0 (0xa015) 1.12
SPU
CCIR (0x0139) 1.0
DV
SGDX (0xa008) 1.0
ACOMP (0xa000) 1.0
SCR
AUDIO0 (0xa015) 1.12
Test OK @
Nucleus Name DS_CHR_TestImageOn
Nucleus Number 101
Description Generates a test-image of a selected video standard on selected video output on the digital
board. When no input is given, the default values will be used (see user input description be-
low). Make sure to use the proper nuclei to route the video signal on the analogue board to get
the videosignal to the proper output.
Technical -Validate the user input.
-Initialise the SYNC module.
-Initialise the DISPLAY module.
-Initialise the MIXER module.
-Initialise the DENC module.
-Set the selected video standard.
-Generate the selected test image in memory.
-Start the DISPLAY module.
-Start the MIXER module.
-Start the DENC module according to the selected test image id.
Execution Time 6 seconds.
家电维修资料网，免费下载各种维修资料
Diagnostic Software
Description
Getting the information succeeded
Wrong codec id detected
INTC (0x011d) 1.0
(0x013b) 1.0 EJTAG (0x0104) 0.1
CONFIG (0x013f) 1.1
UART0 (0x0107) 0.1
UART3 (0x0107) 0.1
GPIO (0x013c) 1.0
DISP1 (0xa00f) 1.1
(0xa00e) 0.0 MIXER (0x0137) 1.0
VDEC (0x0133) 0.2
(0xa00c) 0.0 BEI (0xa00a) 0.1
BYTE (0xa00b) 0.1
VFE (0xa001) 0.1
(0x0000) 0.0 SIFF (0xa011) 0.1
AUDIO1 (0xa00f) 1.1
PCI-XIO(0x0113) 1.0
S-BCU (0x0102) 1.0
RESET (0x0123) 1.0
UART1 (0x0107) 0.1
I2C0 (0x0105) 0.1
SYNC (0x013a) 1.0
OSD (0x0136) 0.1
DENC (0x0138) 1.0
PARSER (0xa00d) 0.0
IDE (0xa009) 0.1
OUTPUT (0xa003) 1.0
VCOMP (0xa002) 1.0
WMD (0xa010) 0.0
PSCAN (0xa018) 0.1