Philips DVDR615 Service Manual page 129

http://www.jdwxzlw.com/?fromuser=华盛维修
Flowchart for test instruction
In the flowchart below it is described how and when the burn in
test has to be carried out.
incoming DVDR set for repair
NO
normal repair
process
short term test procedure
(see REMARK1):
CD-RW low reflection
exchange DVDM
finalize repair/
general functional test of
complete set
家电维修资料网，免费下载各种维修资料
Alignments and Test Procedures
DVDM related
YES
LVP12.01
DVD+R
No
DVDM Fails?
Yes
Exchanged
DVDM?
Yes
NFF process
Remark 2:
NFF process:
- 1st step: contact the customer directly by phone or e-mail to discuss the problem of the set
- 2nd step: if contact with the customer is not possible then add a paper with the returned set,
informing the customer about the possibility to contact the technician directly.
Following information should be mentioned on the paper:
- name of the technician
- company telephone number (extension) of the technician (for direct contact)
- jobsheet number
- information that the set was tested and found to be within the specs. and no failure occured
during the quality and functional check
Figure 8-3
DVDR615/69
Remark 1:
LVP 12.01: 7104 099 91731
DVD+R: record 1 min./stop/open/close/
playback recorded track
CD-RW low refl.: 7104 099 96581
check readability of TOC
long term test procedure:
DVD+RW burn in recording
1h - 2h
(M1/HQ - M2/SP)
No
DVDM Fails?
Yes
No
exchange DVDM
8. EN 129
track 28 --> 31 : 1 min.
: 4 min.
: 1 min.