Philips DVDR615 Service Manual page 48

http://www.jdwxzlw.com/?fromuser=华盛维修
EN 48 5. DVDR615/69
Example
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
Nucleus Name
Nucleus Number
家电维修资料网，免费下载各种维修资料
Diagnostic Software
121202 Reading the data from the UART failed
DS:> 1212 2
121200: The HEX value that was read is: 0x50 0xD1 0x00
Test OK @
DS_SYS_VideoLoopThroughStart
1213
The video signal, which is conform the user input, is routed from the input to the output.
The input is set using the proper nucleus to route the signal on the board(s). All outputs
are enabled.
- Decode the videosignal: PAL / NTSC and Y/C, RGB, CVBS,YUV
- Initialise the Video Input Processor and check for valid signal
- Initialise the Video Front End and start capturing frames to memory
- Initialise the SYNC module
- Initialise the Video Post Processing and retrieve frames from memory
- Initialise the mixer
- Initialise the DENC module
- Route the signal to all outputs
Less than 1 second, but stays running.
<vipInput> <VideoOutput> <VideoStandard>
1. vipInput (CVBS, YC, YUV, RGB, 1 to 9(see table below)).
LECO Premier specific
User input Video input
1 RGB
2 YC
3 CVBS
4 CVBS
5 YC
6 CVBS
7 CVBS
8 YC
9 CVBS
10 XPORT
2. VideoOutput (YUV, RGB).
3. VideoStandard (PAL, NTSC).
Number Description
121300 Video LoopthroughStart succeeded
121301 User input is not valid.
121302 Initialisation of the VIP failed.
121303 Unable to stop the loop through before restarting.
121304 Video Signal on the input is not a valid signal.
121305 Initialisation of the VFE failed.
121306 The digital board hardware information is corrupt
DS:> 1213 CVBS RGB PAL
121300:
Test OK @
DS_SYS_VideoLoopThroughStop
1214
Stop routing the video input to all the outputs.
Stop the DENC and the Video Front End
Less than 1 second.
-
Number Description
121400 VideoLoopthroughStop succeeded
121401 DENC module on Codec failed.
DS:> 1214
121400:
Test OK @
DS_SYS_VideoLoop
1215
Data path to VIP
SCART aux RGB in
SCART aux Y/C in
SCART aux CVBS
Tuner
Front Y/C
Front CVBS
SCART TV CVBS
CE mode Y/C in
CE mode CVBS in
XPORT