Philips DVDR615 Service Manual page 55

http://www.jdwxzlw.com/?fromuser=华盛维修
Nucleus Name DS_SYS_AudioLoopThroughStop
Nucleus Number 1231
Description Stop routing the audio input to all the outputs
Technical Send the Mute command to the audio decoder and reset the audio decoder
Execution Time Less than 1 second.
User Input -
Error Number
123100
123101
123102
Example DS:> 1231
123100:
Test OK @
Nucleus Name DS_SYS_SettingsHwIdSet
Nucleus Number 1232
Description This nucleus sets the HW-Id in the HW-diversity string
Technical -
-
-
Execution Time Less than 1 second.
User Input - The hardware ID to set No input - The user will be asked for the ID
Error Number
123200
123201
123202
Example DS:> 1232
Enter the new HW ID of the digital board (Currently equals 21)
Enter a value between 0 and 99:
> 22
The HW ID will be set to: 22. Is that correct? ([Y/N]):y
123200:
Test OK @
DS:> 1232
Enter the new HW ID of the digital board (Currently equals 22)
Enter a value between 0 and 99:
>
The HW ID will be set to: 0. Is that correct? ([Y/N]):N
123202: Setting the HW ID was aborted by the user.
Error @
DS:> 1232 99
123200:
Test OK @
Nucleus Name DS_SYS_SettingsDoubleCheck
Nucleus Number 1233
Description Double check whether stored HW-string equals actual HW as far as we can
automatically detect this. An automatic and a manual mode is supported.
Technical -
-
-
Execution Time 4 seconds in auto mode when everything matches
User Input -
-
Error Number
123300
123301
123302
家电维修资料网，免费下载各种维修资料
Diagnostic Software
Description
AudioLoopthroughStop succeeded
Resetting the audio decoder failed
Resetting the audio encoder failed
Read out the HW-diversity string
Modify the HW-ID in that string as requested
Write the modified HW-diversity string to the EEPROM
Description
Setting the hardware ID succeeded
Setting the hardware ID failed
The user aborted setting the hardware ID, no changes
made
Read out the HW diversity string
Check whether these settings correspond the actual hardware
In case of modification: Write back the new HW-diversity settings.
'manual' or 'MANUAL' to enter manual mode
default is automatic mode where the nucleus stops upon and reports the first
encountered error
Description
Double checking the HW-diversity settings succeeded
Double check failed, a difference in settings was
encountered
Reading the HW-diversity settings failed
DVDR615/69 5. EN 55