Philips DVDR615 Service Manual page 39

http://www.jdwxzlw.com/?fromuser=华盛维修
Description Turn on the turntable motor
Technical -
-
-
Execution Time Less than 1 second on AV2
4 seconds on AV3
User Input None
Error Number
91500
91501
91502
91503
91504
91505
91506
Example DS:> 915
091500:
Test OK @
Nucleus Name DS_BE_MotorOff
Nucleus Number 916
Description Turn off the turntable motor
Technical -
-
-
Execution Time Less than 1 second on AV2
4 seconds on AV3
User Input None
Error Number
91600
91601
91602
91603
91604
91605
91606
Example DS:> 916
091600:
Test OK @
Nucleus Name DS_BE_Tilt
Nucleus Number 920
Description Test the tilt mechanism control loop, or allow its proper functioning to be measured.
Before executing this nucleus a disc must be loaded in the recorder
Technical -
-
-
Execution Time Approximately 15 seconds
User Input None
Error Number
92000
92001
92002
92003
92004
92005
92006
92007
92008
92009
92010
家电维修资料网，免费下载各种维修资料
Diagnostic Software
Check if an AV2 or AV3 is connected
In case of an AV2 Send the TURN_TABLE_MOTOR_ON command
In case of an AV3 Send the transparent BIT engine TTM command
Description
Turn table motor is on
There was a time-out while communicating
The Basic Engine returned an unexpected result
The BE returned an error code
No acknowledge received from BE
Communicating with the Basic Engine failed
Unable to enter service mode
Check if an AV2 or AV3 is connected
In case of an AV2 Send the TURN_TABLE_MOTOR_ON command
In case of an AV3 Send the transparent BIT engine TTM command
Description
Turn table motor is off
There was a time-out while communicating
The Basic Engine returned an unexpected result
The BE returned an error code
No acknowledge received from BE
Communicating with the Basic Engine failed
Unable to enter service mode
Check if an AV2 or AV3 is connected
In case of an AV2
- Send the TRAY_IN command
- Send the READ_TOC command
- Send the TILT_COMMAND command with parameter 0x00 0x00
- Send the TILT_COMMAND command with parameter 0x00 0x02
In case of an AV3 display a "not supported" message
Description
The command executed successfully
There was a time-out while communicating
The Basic Engine returned an unexpected result
The Basic Engine returned an error code
No acknowledge received from BE
Unable to send tray in
Unable to read the disc
No disc is loaded
Unknown disc is loaded
Unable to enter service mode
This nucleus is not supported by the engine
DVDR615/69 5. EN 39