Philips DVDR615 Service Manual page 53

http://www.jdwxzlw.com/?fromuser=华盛维修
Nucleus Name DS_SYS_DisplayFatalOff
Nucleus Number 1224
Description Turn off the display-fatal functionality which displays debug-information on the display
when encountering a fatal error condition from which could not be recovered
automatically
Technical Issue the command to stop using the display-fatal functionality to the analogue board
Execution Time Less than 1 second.
User Input None
Error Number
122400
122401
122402
122403
122404
122405
122406
122407
Example DS:> 1224
122400:
Test OK @
Nucleus Name DS_SYS_DisplayFatalGet
Nucleus Number 1225
Description Get the display-fatal flag of the recorder
Technical Issue the command to get the status of the display-fatal functionality to the analogue
board
Execution Time Less than 1 second.
User Input None
Error Number
122500
122501
122502
122503
122504
122505
122506
122507
122508
Example DS:> 1225
122500: The Display Fatal functionality is ON
Test OK @
Nucleus Name DS_SYS_SettingsSet
Nucleus Number 1226
Description Programs the digital board settings into the boot EEPROM on the digital board.
Technical Evaluate user input. Set-up IIC-bus. Write data to boot EEPROM. Update checksum.
Execution Time 1 second
User Input A large hexadecimal value that represents the digital board settings obtained from the
XDIVTOOL.exe program or from a reference set.
Error Number
122600
122601
122602
Example DS:> 1226 646961677473746201010200010101010101000020080000
122600:
Test OK @
Nucleus Name DS_SYS_SettingsDisplay
Nucleus Number 1228
Description Show the settings that are programmed in the BROM on the digital board.
Technical Set-up IIC-bus. Read Digital Board Settings from boot EEPROM. Display the settings.
家电维修资料网，免费下载各种维修资料
Diagnostic Software
Description
Turning off the display-fatal functionality succeeded
Turning off the display-fatal functionality failed
The returned errorcode from the analogue board is
unknown:
No DS errCode known for analogue board error:
There was no response from the analogue board.
Section validation or write failed in NVRAM
Reading the section from NVRAM failed
Initialisation of IIC or reaching NVRAM failed
Description
Getting the display-fatal flag succeeded
Getting the display-fatal flag failed
The returned errorcode from the analogue board is
unknown:
No DS errCode known for analogue board error:
There was no response from the analogue board.
Reading the display fatal flag failed
Initialisation of IIC or reaching NVRAM failed
Unexpected version read from NVRAM section
Reading the fatal flag from NVRAM failed
Description
The settings were successfully programmed.
User input is invalid.
IIC access failed.
DVDR615/69 5. EN 53