Baseboard - Fujitsu Primergy RX300 S4 User Manual

Chapter 1 Overview

1.3.4 Baseboard

[Front]
a
b
c
a USB FRONT connector
Connect a cable for the USB connector on the front of the server.
b USB connector
Connect a USB cable when installing an internal USB backup device.
c SATA1 connector
Connect a SATA cable of the CD/DVD drive.
d Power connector
Connect a power supply unit cable.
e CPU sockets
Install a CPU.
f Memory board slot
Install memory board that contains memory module.
g Parallel port connector
Connect a parallel port cable when an optional expansion parallel port is installed.
h Serial port connector
Connect a serial port cable when an optional expansion serial port is installed.
i PCI slot
Install an expansion card.
j Switch block
For the switch block settings, refer to "7.1 Switch Block Settings" ( p.182).
28
d e
[Rear]
j
i
f g h