Configuring A Backup Job - Buffalo TeraStation TS3400D User Manual

4
Click Add under "Off-subnet Devices", enter the IP address of the target LinkStation or TeraStation, and click
Close.
If your setup meets the requirements below, you don't have to configure these settings:
• The source and target TeraStations are on the same network.
• No backup password is set for the target TeraStation.
• No TeraStation from outside the subnet, or connected by a VPN, is used.
Notes:
• To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that
both devices are configured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes are
significantly different, the backup job may not be properly performed. In such a case, select the default frame
size (1500 bytes).
• You can also specify hostname by a fully qualified domain name (FQDN).

Configuring a Backup Job

1
In Settings, click Backup.
2
Click to the right of "Backup".
84