Chapter 12 Appendix; Lcd Display; Modes; Errors - Buffalo TeraStation TS3400D User Manual

Chapter 12 Appendix

LCD Display

The LCD display can be cycled through different modes by pressing the display button on the front of the
TeraStation. Also, the items displayed can be configured at Management - Notifications - Front Panel Display Settings
in Settings.

Modes

LCD Message
LINK SPEED
No LINK
LINK SPEED
LINK SPEED
10 Mbps HALF
Note: When an
LINK SPEED
Ethernet cable
10 Mbps FULL
is connected
LINK SPEED
to LAN Port 2,
100 Mbps HALF
"LINK SPEED 2"
LINK SPEED
is displayed.
100 Mbps FULL
LINK SPEED
1000 Mbps
Hostname / IP TSxxxx xxx
Address 192.168.11.150
DATE TIME
Calendar / Clock
2012/1/1 11:11

Errors

LCD Message Description
BOOT FAIL Hard drive not found.
SYSTEM Error E04
The firmware is corrupted.
Can't Load Krnl!
The TeraStation is running on the UPS
E10 UPS Running
battery due to a power outage. The system
Off Battery
will now be shut down safely.
I10 System Is A rise in the system temperature may have
Overheating exceeded the allowable safety value.
Description
Not connected to network.
Connected at 10 Mbps half duplex.
Connected at 10 Mbps full duplex.
Connected at 100 Mbps half duplex.
Connected at 100 Mbps full duplex.
Connected at 1000 Mbps full duplex.
Displays the hostname and IP address. At the
end of the IP address, F (fixed IP address) or D
(IP address automatically acquired from a DHCP
server) is displayed.
Note: When an Ethernet cable is connected to
LAN port 2, "NETWORK2" is displayed in the
hostname section.
Displays the date and time set in the TeraStation.
204
Corrective Action
Connect an Ethernet
cable to the LAN port.
-
-
-
-
-
-
-
Corrective Action
Contact Buffalo technical support for
assistance.
Contact Buffalo technical support for
assistance.
Check that power is being supplied to the
UPS, and if there are no problems, turn on
the TeraStation.
Move the TeraStation to a cool location. Do
not place objects in the area around the
TeraStation.