Buffalo TeraStation TS3400D User Manual page 80

6
Close the front cover.
7
When the replacement hard drive is recognized, the status LED will flash red and the I31 message will be
displayed on the LCD panel.
8
Hold down the function button on the front of the TeraStation for 3 seconds until it beeps.
For RAID 1, 5, or 6:
The TeraStation will start rebuilding the RAID array automatically. After a few minutes, the I18 message will be
displayed until the array is rebuilt.
For JBOD:
The drive will be formatted as an individual drive. Create a shared folder on the drive before use.
Drive Replacement (using a redundant RAID mode such as RAID 1, 5, or 6 with auto-
shutdown enabled)
This section describes the process of replacing a drive while
1
Open the front cover with the key.
2
Push the unlock button of the failed hard drive and swing the lock mechanism out.
3
Pull out the drive cartridge and remove it from the TeraStation.
4
Insert the new hard drive into the empty slot. Slide the drive in with the locking mechanism open. Swing the
lock back down until it clicks into place.
5
Close the front cover.
6
Press the power button on the TeraStation.
7
When the replacement hard drive is recognized, the status LED will flash red and the I31 information message
will be displayed on the LCD panel.
8
Hold down the function button on the front of the TeraStation for 3 seconds until it beeps. The TeraStation will
start rebuilding the RAID array automatically. It will take about 5 minutes before the I18 message is displayed.
Drive Replacement (RAID 0)
Drives in a RAID 0 array do not automatically turn off in the event of a malfunction. Before replacing the failed drive,
either dismount the drive from Settings, or shut down the TeraStation.
the TeraStation is off.
79