3
Click the LAN port where the IP address will be changed.
4
Disable "DHCP" and enter the desired network address settings, then click OK.
Notes:
• Do not set the same address for LAN port 1 and LAN port 2. This may cause unstable network
communication.
• Use LAN port 1 to access different network subnets from the TeraStation. Access to a different network
subnet is not possible from LAN port 2 since it doesn't have a default gateway.
• The following IP addresses are reserved and should not be used. If you configure one of them by accident,
initialize all settings with the init button on the TeraStation.
Local loopback address: 127.0.0.1, 255.255.255.0
Network address: 0.0.0.0, 255.255.255.0
Broadcast address: 255.255.255.255, 255.255.255.0
The IP address range from 224.0.0.0 to 255.255.255.255
193