6
Click
to the right of "UPS Sync".
7
Click Edit.
8
Configure the desired settings, then OK.
Notes:
• If the TeraStation is connected directly to a UPS, select "Sync with UPS connected to this TeraStation". If a
different TeraStation is connected to the UPS, select "Sync with UPS connected to another LinkStation or
TeraStation on the same network". After making this selection, enter the IP address of the TeraStation that will
be the sync source in "Other LinkStation or TeraStation's IP Address".
• When the TeraStation is rebooted after an automatic shutdown (such as from a power outage or power
supply problem), verify that the power supply has been restored. If the TeraStation is turned on while it is
still running on the UPS and without the power supply restored, automatic shutdown is not performed, even
after the specified time has elapsed.
• If the power supply from the UPS to the TeraStation is stopped and restarted when UPS recovery is enabled,
the TeraStation is automatically restarted.
Port Trunking
Two Ethernet cables can be used to establish two separate communication routes providing LAN port redundancy
and improving communication reliability. The use of two Ethernet cables enables access to the TeraStation even if
one of the cables is disconnected.
The port trunking modes that can be set in the TeraStation are shown below.
Trunking Mode
Round-robin
Characteristics
Network packets are transmitted in sequential order from the first
available NIC slave through the last.
164