Accessing From An Nfs Client - Buffalo TeraStation TS3400D User Manual

Notes:
• Don't disable the SMB protocol while DFS is enabled. If you do, you will need to enable SMB again and
reconfigure DFS from scratch.
• TeraStations, LinkStations, and SMB-compatible Windows computers can be specified as DFS link targets
(Mac OS and Linux are not supported).

Accessing from an NFS Client

Note: (US purchasers only) Buffalo's customer support will help configure the NFS settings on your TeraStation,
and will support VMware and Windows clients but will not provide support for configuring your Linux or
other UNIX clients. There are many types of UNIX and the procedures for configuring NFS with them will vary
considerably. For help configuring your NetWare, Linux, or other UNIX clients for NFS support please consult
each client's own documentation and support.
1
In Settings, click File Sharing.
2
Click to the right of "Folder Setup".
3
Choose the shared folder that will be accessible to the NFS client.
4
Click Edit.
5
Under "LAN Protocol Support", check "NFS" and click OK.
Note the NFS path. It will be used later for accessing data from an NFS client.
6
Click Close.
7
Move the NFS switch to the
8
Click to the right of "NFS".
9
Click Client Settings.
position to enable NFS.
172