Table of Contents
Advertisement
4
Click Add, enter the IP address of the target LinkStation or TeraStation, and click Close.
If your setup meets the requirements below, you don't have to configure these settings:
•
The source and target TeraStations are on the same network.
•
No backup password is set for the target TeraStation.
•
No TeraStation from outside the subnet, or connected by a VPN, is used.
Notes:
• To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that both de-
vices are configured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes are significantly dif-
ferent, the backup job may not be properly performed. In such a case, select the default frame size (1518 bytes).
• You can also specify hostname by a fully qualified domain name (FQDN).
Configuring a Backup Job
1
In Settings, click Backup.
2
Click
to the right of "Backup".
70
Advertisement
Table of Contents
