Restoring Factory Defaults; Initializing From Settings - Buffalo TeraStation TS3400D User Manual

6
Click Import.
7
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
8
When the following message is displayed, transferring settings is finished. Click OK.
Notes:
• If the migration target TeraStation contains shared folders, users, and groups that share the same name as the
transferred settings, the existing settings will be overwritten.
• If the migration target TeraStations have already added some shared folders, users, and groups, the
transferred settings may exceed the maximum number of allowed shared folders, users, or groups. After
migration finishes, open Settings and verify that all settings were properly transferred.

Restoring Factory Defaults

There are several ways to initialize the TeraStation and restore its factory default settings. One simple way to do this
is to hold down the init button (refer to the TeraStation diagram in chapter 1) on the front panel for three seconds.
Normally this will reset the admin username and password, network configuration, SSL, and security port settings
to their factory default values. However, this button can be disabled in Settings. If the init button is disabled, refer to
the methods below on how to initialize the TeraStation.

Initializing from Settings

To initialize the TeraStation to its factory defaults from Settings, follow this procedure.
1
In Settings, click Management.
2
Click to the right of "Restore/Erase".
3
Click Initialize TeraStation.
4
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
5
The TeraStation will be restored to its factory default settings.
183