Buffalo TeraStation TS3400D User Manual page 175

The mount command depends on your operating system. The examples below assume that IP address of your
TeraStation is 192.168.11.10, "/mnt/array1/share" is the desired NFS path, and "/mnt/nas" or drive letter "z" is
the mount point.
For Linux:
mount -t nfs 192.168.11.10:/mnt/array1/share /mnt/nas
For Windows Service for Unix 3.5:
mount 192.168.11.10:/mnt/array1/share z:
For Solaris 10:
mount -F nfs 192.168.11.10:/mnt/array1/share /mnt/nas
Notes:
• To restrict NFS access to a specific network or client, navigate to File Sharing - NFS - Services and click Edit.
Enter the address of the network. For example, if your local network subnet has a router at 192.168.1.1 and
clients with IP addresses in the range from 192.168.1.2 through 192.168.1.48 with subnet mask 255.255.255.0,
then the "Public Network Address" would be 192.168.1.0 and the "Public Subnet Mask" would be
255.255.255.0. This would mean that only clients on this local network would be able to access the NFS share.
If the default settings are used (0.0.0.0 for both the public network address and the public subnet mask), then
access to the NFS share will not be restricted.
• To use NFS folders with VMware ESX/ESXi or Citrix, navigate to Services - Edit and change the operation mode
from "User Mode" to "Kernel Mode".
• Async is the default for NFS rules. Sync is available only when the device is in kernel mode.
• To restrict access to a NFS share for specific clients, navigate to File Sharing - NFS - NFS Rules and click Add
Rule. Choose the folder to restrict access to, and enter the clients that will have restricted access in the "Hosts"
field. Clients may be entered by hostname, IP address, or IP address range. Wildcards are supported. Separate
174