Configuring A Backup Job - Buffalo LinkStation 200 Series User Manual

Chapter 6 Backup
passwords for backup, but only one password can be used on the LinkStation. Folders that are configured
with a different password cannot be used.
• A backup password is not available when a new shared folder is created by a power user.
A backup destination has been created.
Note: If you want to back up to a Buffalo NAS device on another network, follow the procedure below to add the
Buffalo NAS device so it can be used as a backup destination.
(1) From the Backup Job Settings screen, click [LinkStation and TeraStation List].
(2) Click [Add]; enter the IP address or hostname/FQDN of the destination Buffalo NAS device, then click [OK].
(3) Click [Close] when completed.
(4) Click [Refresh] and make sure the desired Buffalo NAS device has been added to the list.

Configuring a Backup Job

You can configure backup jobs by using another shared folder on the Buffalo NAS device or a USB drive connected
to the LinkStation as a destination. You can also back up to a Buffalo NAS device on another network as long as the
two networks are connected by a VPN or the route is configured properly.
1
From Advanced Settings, click [Backup].
2
Click to the right of "Backup".
3
If you had configured a backup password for the backup source folder on another Buffalo NAS device or the
backup destination folder, click [Set]. If you hadn't, skip to step 5.
64