Troubleshooting:
If the settings are not saved to the USB memory device successfully, you may receive the error message "The
specified operation cannot be executed.". Verify:
• The device is connected to a USB 2.0 port, not a USB 3.0 port.
• The device has a capacity of 1 GB or larger.
• The device is not write-protected.
Applying Settings
The saved settings can be applied to a different TeraStation (of the same series).
1
Connect the USB memory device with the saved settings to a USB 2.0 port of the TeraStation (not a USB 3.0
port).
2
In Settings, click Management.
3
Click
to the right of "Configuration Management".
4
From "Target USB drive", select the USB memory device that is connected to the USB 2.0 port of the
TeraStation.
5
Select "Transfer settings from a USB drive", then click Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
When the following message is displayed, applying settings is finished. Click OK.
181