Table 3.2 Parts On The Rear Panel Of The Cabinet; Mp10/Mp10A Processor Card - Samsung OfficeServ 7100 Installation Manual

OfficeServ 7100
TECHNICAL MANUAL
Slot
Slot 1 and Slot 2
(universal slots)
NOTE: The OfficeServ 7100 only supports PRI service and does not support T1 service
even though the TEPRI and TEPRIa cards support both.
The descriptions about each part on the rear of the cabinet are listed in the table below.
Part
Power Switch
AC Power connector
AC LED
DC LED
Battery Socket
Ground Lug

3.2 MP10/MP10a PROCESSOR CARD

This section describes the procedures for setting switches and installing optional daughter
cards on the MP10/MP10a as well as installing the MP cards in the processor slot.
The OfficeServ 7100 MP10/MP10a (Main Control Processor) controls the system operation.
The MP10/MP10a is required for all configurations and goes only in slot 0 of the cabinet.
The MP10/MP10a comes standard with a built-in 4 port Voice Mail/Auto Attendant and 8 VoIP
MGI (Media Gateway Interface) channels. The MGI features and capacities are controlled by
license keys entered in system programming.
NOTE: This manual covers the installation and startup of both the MP10 and MP10a processor
cards. Take note that the SD media cards are different and they are not compatible. Verify
that the MP10 MMC+/SD card is installed in the MP10 and the MP10a SD card is installed in
the MP10a.
Cards Allowed
- OS7100 Card allowed: UNI cards
- OS7200/OS7400 Cards allowed: 8DLI, 16DLI2, 8SLI,
16MWSLI, 8COMBO/8COMBO2, 8TRK, 8TRK2, 16TRK,
TEPRIa, MGI-16

Table 3.2 Parts on the Rear Panel of the Cabinet

Power on/off switch for the OfficeServ 7100 system.
Connector for the power cable connection
The LED indicates the input of AC power.
The LED indicates the normal output of DC power.
Connector for an external battery
Connection for system ground cable.
3.2
Home Page
INSTALLATION
PART 3 MAY 2010
Function
Table of Contents