Samsung OfficeServ 7100 Installation Manual page 35

Home Page Table of Contents
OfficeServ 7100 INSTALLATION
TECHNICAL MANUAL PART 3 MAY 2010
Figure 3.12 Replacing a Card
3.3.3 Installing UNI Cards and Daughtercard Modules
The UNI card is a universal base carrier card that can accommodate up to 3 optional
daughtercards. The UNI card by itself serves no function. The UNI card can be installed in slot
1 and/or slot 2.
The UNI card has three positions to mount optional daughtercard modules. The mountable
daughtercard modules are 4TRM, 4DLM and 4SLM. Up to three modules can be mounted
regardless of the option module type. Any of these daughtercards can go into any of the 3
positions. The interface ports for each card are located on the front panel of the UNI card and
are labeled accordingly.
Align the module to be mounted to the top connector (16-pin connector). After that, match
the bottom connector (100-pin connector). Push the daughtercard in carefully until the card
is fully seated into the connectors. Lock the supporter between the grooves and the top of
each option card with screws.
Remove screws from UNI card before mounting the daughtercards then re-screw them in to
lock down the daughtercards.
4SLM
4TRM
Figure 3.13 Installing the UNI Card
3.14