Samsung OfficeServ 7100 Installation Manual page 80

OfficeServ 7100
TECHNICAL MANUAL
SMT-i5264 ADD ON MODULE
The SMT-i5264 module can be used beside any ITP 5100 keysets, SMT-i Series, and TDM
phones . The cosmetic design matches the SMT-I 5000 Series phones. The SMT-i5264 Add On
Module only attaches to SMT-i5200 Series.
To attach the SMT-i5264 AOM to any SMT-I 5000 Series phones follow the steps below:
1) Remove the SMT-i5264 AOM stand and the cradle of the phone by pressing the
[Push] mark on the top of the cradle to push it out.
2) Attach the bracket to the keyset with two of the screws provided.
3) Attach the SMT-i5264 AOM module to the bracket with the remaining two screws.
4) To connect to the phone, connect the UTP cable between the port and the LAN
port of the IP phone.
5) To connect to the switch, connect the UTP cable between the LAN port and a port
of the switch.
6) Add the stands back to the phone and AOM unit.
NOTE: SMT-i5264 AOM requires either PoE or a Power Adaptor (sold separately).
If PoE is used, PoE connection should be connected to the LAN port of the SMT-i5264 (AOM)
first then transfer over to the phone. As shown in Figure 7.17 the SMT-i5264 (AOM) can
transfer the power from the LAN port to the phone port, but the phone can't transfer power
to the AOM.
(See Figure 7.17).
Figure 7.17 Attaching SMT-i5264 AOM to phone
7.16
Home Page Table of Contents
INSTALLATION
PART 7 MAY 2010