Samsung OfficeServ 7100 Installation Manual page 27

OfficeServ 7100
TECHNICAL MANUAL
3) The optional 4DLM daughtercard (installed in the connector located towards the front of
the MP10/MP10a)
The optional modem daughtercard is mounted to connector P7 of the MP10/MP10a card.
This modem daughtercard allows remote dial up connection to the system for system
administration and configuration. This is an alternative method for connecting to the system
when a LAN/WAN connection is unavailable. The modem board has the following functions:
• The MP10/MP10a board supports a 2-Wire Full Duplex modem board. This is the same
modem used on the OfficeServ 500 system.
• The modem board operates in OfficeServ 7100 via V.24 interface. In addition, the modem
board supports V.90 protocol. OfficeServ 7100 controls the modem board via serial
communication using standard AT commands. When mounting a modem card, the holes
on the corners of the modem should be aligned such that the spacer fits in the hole in the
following figure.
Figure 3.3 Mounting a Modem Card on the MP10/MP10a
3.6
Home Page Table of Contents
INSTALLATION
PART 3 MAY 2010
MODEM