Samsung OfficeServ 7100 Installation Manual page 64

OfficeServ 7100
TECHNICAL MANUAL
PARAMETERS supported on OfficeServ all TEPRI cards installed in the 7100
FRAMING
Super Frame (D4 56K Frame)
Extended Super Frame (ESF 64K Frame)
CODING
AMI - 56K Coding
B8ZS - ESF 64k Coding
NFAS (Non Facility Associated Signaling)
Use MMC 808 to set the parameters to match the Telco PRI circuit.
Pin No. 1
PRI Rx+
Function
6.2.3 Connecting a SIP Trunk
There is no physical SIP trunk card required to use the SIP trunking service. However, in order
to use the SIP trunking service, the OfficeServ system must be IP-enabled. That means that
the OfficeServ system must have an MGI card with the latest MP software and have high
speed Internet connection.
Please refer to the "OfficeServ Series SIP Trunking Quick Reference Document" for
configuration.
T1 Circuit
Not Supported
Not Supported
T1 Circuit
Not Supported
Not Supported
Not Supported
PRI Port
(RJ-45)
2 3 4
Rx- - Tx+
Figure 6.2 RJ-45 Port of TEPRI/TEPRIa
6.3
Home Page
PART 6 MAY 2010
PRI Circuit
Not Supported
Yes
PRI Circuit
Not Supported
Yes
Not Supported
5 6 7
Tx- - -
Table of Contents
INSTALLATION
8
-