Samsung OfficeServ 7100 Installation Manual page 93

OfficeServ 7100
TECHNICAL MANUAL
INSTALLATION TOOL AND MODEM CONNECTION VIA TELCO LINE
This example is based on a PC using an internal modem card. Connect Telephone line cord
from internal modem connection of PC directly to loop start telco line.
1. Execute OIT.
2. Click [System] -> [Link Control] menu to set the communications link.
3. Enter System Name (e.g. ABC Company).
4. Select the <link type> (e.g. MODEM).
5. Input the Telephone number (e.g. 972-372-4812).
6. Input the Com Port (e.g. COM1).
7. Input the Baud Rate (e.g. 38400bps).
8. Click [Apply].
9. Dialog box shows: "Do you want to apply new setting value?"
10. Click [Yes].
11. Dialog box shows: "The new setting value is applied."
12. Click [OK]. Click [Close].
13. Click [System]. Click [Connect].
14. Enter Password [Samsung], then [OK].
NOTE: Internal modem card must be installed for the connection to work. The incoming
telco line may need to be programmed to ring directly to modem port of OfficeServ
7100 system in MMC 406 (e.g. Trunk 701 ring to port 3999).
Figure 7.26 OIT and Modem Connection
7.29
Home Page Table of Contents
INSTALLATION
PART 7 MAY 2010