OfficeServ 7100
TECHNICAL MANUAL
3) Hold the 7100 cabinet against the wall in the desired direction. There are four (plus +
shaped) holes on the top and bottom of the bracket (see positions marked A in the figure
below). Mark the top two holes on the desired wall then mark the two holes on the
bottom brackets.
4) Using a 3/16" drill bit, make holes on the marked positions of the top and bottom
brackets.
Position A
Mark Holes
Figure 2.8 Mounting the 7100 Cabinet on the Wall
Figure 2.9 Making Holes for Top and Bottom Brackets
2.6
Home Page
Table of Contents
INSTALLATION
PART 2 MAY 2010