Samsung OfficeServ 7100 Installation Manual page 25

OfficeServ 7100
TECHNICAL MANUAL
• Switches 1 through 4 select the country the system is installed in.
4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Switch 5 is reserved.

These DIP switches will not take effect unless the switches are set in the wanted position

and the system memory is cleared manually by using the Memory Backup switch.
3.2.1b Setting Switches on MP10a
On the MP10a set the switches for the required configuration. The description for the settings
is described below.
• Memory Backup Switch (S1): There is no memory backup switch on the MP10a card. All
the system programming is saved by NAND flash even when the system is restarted or
powered off. System programming is saved in NAND flash indefinitely until the system is
defaulted. It is recommended that all system programming be periodically saved to the
MP10a SD card or to a PC using the OfficeServ Installation Tool Application. To default the
system programming during live operation on the MP10a card, press and hold in the RST
3 2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
Figure 3.2b Switch Setting (MP10a)
3.4
Home Page
1 Country
OFF Korea
ON USA
OFF UK
ON Italy
OFF Australia
ON New Zealand
OFF Holland
ON Denmark
Table of Contents
INSTALLATION
PART 3 JULY 2010