OfficeServ 7100
TECHNICAL MANUAL
6) Tighten the mount locking screws into the remaining two holes among the four screw
holes on the bottom of the OfficeServ 7100 cabinet. At this point, do not tighten
completely, but keep the screws out about 2mm.
7) Align the screws on the bottom of the OfficeServ 7100 cabinet to the bracket holes, then
pull down the cabinet to lock the cabinet securely.
Figure 2.18 Installation on a Wall (6)
2 mm
Figure 2.19 Installation on a Wall (7)
2.11
Home Page
Table of Contents
INSTALLATION
PART 2 MAY 2010