Table of Contents
Advertisement
13-26
Useful advice for emergencies
2 Replacing the fog lamp bulb
•
Removal
1. Tilt up the cab if it has a tilting mechanism.
2. Remove the cover
clockwise to a stop.
3. Disconnect the bulb connector
4. Disconnect the connector
5. Unhook the spring
Z21141
•
Installation
1. Hold the bulb with the square groove
top (with the circular groove
then align the bulb with the lugs
lamp unit, install it and fix it with the spring
2. Reconnect the connector
3. Reconnect the connector
4. Clean the packing
straighten the packing if it is twisted.
5. Install the cover on the lamp unit and turn it
clockwise.
Z21437
6. Lower the cab if it was tilted up.
3 Front and side turn signal lamp bulb
replacement
1. Open the door.
2. Turn the socket
remove it.
3. Press the bulb
arrow
4. Perform installation by following the removal
steps in reverse.
5. If the packing
Z21438
4 Interior lamp bulb replacement
4.1
Type 1 <front and rear seats>
1. Insert a flat-blade screwdriver
lens
release the tabs
Remove the lens.
2. Push the bulb retainer
the bulb
3. To install the lens, insert the tabs
the lens and press the bottom of the lens into
place.
Z09125
after turning it counter-
, then pull out the bulb
in the direction of arrow
and turn it in the direction of
to remove it.
is dirty, clean it.
and the interior lamp
on the bottom of the lens.
rightward and remove
.
.
from the lamp unit.
.
at the
at the bottom),
on the fog
.
of the bulb.
to the fog lamp unit.
if necessary. Also
between the
and use it to
on the top of
to
Advertisement
Table of Contents
