Mitsubishi Fuso Canter 2013 Owner's Manual page 356

13-24
Useful advice for emergencies
4. Insert the grommet
grommet hole
tighten the screws
CAUTION
Do not tighten the screw too tightly or the
mounting could get damaged.
Z21433
5. Install the connector
signal lamp
6. Pull out screws
7. Align the tabs
the lamp in toward the centerline of the vehicle.
Z11274
Z21434
8. Open the door, then tighten the screws
behind the front and side turn signal lamp
CAUTION
•
Press the front and side turn signal lamp
fully in toward the centerline of the vehicle. If
the lamp was not pressed fully into place
and you opened the door, the door could hit
the lamp and damage it.
•
Do not tighten the screws too tightly or the
Z21435
mounting could get damaged.
9. Fit the lamp rubber
onto the tabs
of the vehicle.
10. Fit the rivet
Z21436
on the garnish
, fit the garnish in place, and
.
on the front and side turn
.
.
with the holes
under the headlamp
by moving it toward the outside
, then press in the screw
into the
, then press
.
.