Table of Contents
Advertisement
•
When you press the buttons, be sure to press
them for at least one second. If a button does
not work after one press, press the button again
after one or two seconds.
•
After locking the doors with the remote control
switch, always check that the doors are locked
by lifting the outside handle of a door.
•
You can check the locking/unlocking of the
doors by the flashing of the hazard lamps and
the room lamp. Leave the switch of the room
lamp
When the doors are locked, the room lamp and
the hazard lamps flash twice.
When the doors are unlocked, the hazard lamps
flash once and the room lamp lights up for about
10 seconds.
•
If you do not open a door within 30 seconds
after unlocking with the remote control switch,
Z11389
the doors will automatically be locked again.
NOTE:
•
The range in which you can operate the remote
control varies somewhat depending on the sur-
roundings, such as proximity to a TV tower,
power station, broadcasting station, etc.
•
If you lose the remote control switch or the
switch does not work, please contact an autho-
rized dealer. The dealer will produce two new
spare remote control switches for you.
The remote control switch does not work under the
following conditions:
•
A door is open or incompletely closed.
•
The starter key is in the starter switch.
4 Replacing the remote control switch battery
The battery may have run down if the remote con-
trol switch does not lock or unlock the doors upon
pressing the corresponding button. Replacing the
battery will solve the problem.
WARNING
•
Keep the batteries out of the reach of chil-
dren. If a child swallows a battery, visit a
doctor immediately.
•
Do not disassemble, heat or drop the bat-
tery in water. Doing so could cause a fire
or explosion.
"•" (in the center "•" position).
3-11
Advertisement
Table of Contents
