Passing Signal/Dimmer Switch; Turn Signal Lamp Switch; Exhaust Brake - Mitsubishi Fuso Canter 2013 Owner's Manual

3 Passing signal/dimmer switch

Passing signal
Pulling the lever up activates the high beams until
the lever is released. Use this to flash a signal when
overtaking another vehicle.
Dimmer
With the headlamps illuminated, pushing the lever
down activates the headlamp high beams and pull-
ing it back to the original position reactivates the low
Z21346
beams. When the high beams are on, indicator
lamp

4 Turn signal lamp switch

Turn signal
Moving the lever forward or backward activates the
corresponding turn signal causing it to flash. At the
same time, the corresponding indicator lamp
flashes.
When the steering wheel is returned to the neutral
position after a right or left turn, the switch automat-
ically moves back to the neutral position and the
lamp stops flashing. After making a moderate turn,
Z21347
however, the switch will sometimes not return auto-
matically. In this case, put the switch in the neutral
position by hand.
Lane changer
Lightly pushing the lever forward or backward
causes the corresponding turn signal lamp to flash
while the lever is held in this position.
5 Exhaust brake <Option>
WARNING
Using the exhaust brake on a wet, frozen,
snow-covered, or otherwise slippery road
surface when the vehicle is lightly loaded or
not loaded can cause the tires to slip on the
road surface, resulting in a skid. Do not use
the exhaust brake on slippery road surfaces.
The exhaust brake enhances engine braking. Use it
as an auxiliary braking means on downhill stretches
or during high-speed driving.
lights up.
5-17
or