Table of Contents
Advertisement
<Multi-information display>
•
While the accelerator pedal or brake pedal is
being depressed
•
While the vehicle is moving
•
When the gearshift lever is in any position other
than "P" or "N"
1. Park the vehicle in a safe place and warm up the
engine.
2. Firmly engage the parking brake. Place the
gearshift lever in the "P" or "N" position and then
wait for at least 30 seconds.
3. If your vehicle is equipped with a PTO, make
sure the PTO is disengaged.
Z21720
4. With the engine still in operation, continuously
press the "ON" side of the DPF cleaning switch
until the
and shifts to continuous illumination. The engine
will increase its idling speed (to approx. 1,500
rpm) to start the parked DPF regeneration.
When the parked DPF regeneration is started,
the predicted time until completion of the regen-
eration is indicated on the multi-information dis-
play. The exhaust brake valve may also operate
Z21721
during the parked DPF regeneration.
5. The predicted time indication shows a time near
0 minute, the idling speed of the engine returns
to the original idling speed (approx. 650 rpm),
and the
6. Once the parked DPF regeneration is com-
pleted, you may drive the vehicle normally.
7. If you need to suspend the parked DPF regener-
ation before completion of the sequence,
repress the "ON" side of the DPF cleaning
switch or depress the accelerator pedal.
NOTE:
•
When you deliberately suspend the parked DPF
regeneration, complete the remaining part of the
sequence without delay by performing the
above steps again.
•
If the PM amount is indicated by 7 or more seg-
ments, you can start parked DPF regeneration
even during automatic DPF regeneration by
using the above method.
Z21281
indicator lamp
indicator lamp
goes out.
5-57
stops flashing
Advertisement
Table of Contents
