Table of Contents
Advertisement
5-4
Switches and controls
•
LOCK
The starter key
in this position only. To place the key in the
"LOCK" position, turn it to the "ACC" position
then press it in. Keep it pressed in while turning
it to the "LOCK" position. When the key is
removed, the steering wheel locks.
The lighting switch, hazard warning lamps, inte-
rior lamp, horn, central door locks and turn sig-
nal lamps can be used.
•
ACC
The engine is shut off or is not running in this
position.
The cigarette lighter can be used. Audio equip-
ment (radio, etc.) installed and connected in the
approved manner can also be used.
•
ON
The engine is running in this position.
All electrical circuits are operable.
•
START
The engine is turned over and started in this
position.
Z21341
Once the engine is running, release the key and
the switch will automatically return to the "ON"
position.
NOTE:
•
Turn the key only after inserting it fully in the
starter switch.
•
If you are unable to turn the key, gently turn the
steering wheel clockwise and counterclockwise
as you turn the key.
•
The starter key can neither be turned to the
"LOCK" position nor pulled out unless the gear-
shift lever is in the "P" position.
2 Starter key reminder alarm
A buzzer sounds if you open the door with the
engine shut down and the key left in the starter
switch. Remove the starter key from the switch and
keep it with you whenever leaving the vehicle.
can be inserted and removed
Advertisement
Table of Contents
