Mitsubishi Fuso Canter 2013 Owner's Manual page 278

12-42
Simple inspection and service
6. Remove the oil filter case by turning it counter-
clockwise. Use a rag
ping down.
Z21175
7. Remove the filter element
If the claw of the filter element is too firmly
engaged to remove the element, insert an Allen
wrench
the element.
Z22308
8. Clean the O-ring contact surface of the oil filter
support
case.
9. Replace the O-ring
new one. Apply a light coat of engine oil to the
new O-ring before installing it.
CAUTION
•
Use only the O-ring supplied with a new
replacement filter element.
Z21178
•
Do not tighten the air plug and filter case
beyond the specified torque. The air plug
and filter case could be broken if over-tight-
ened.
10. Replace the filter element
use only a genuine filter element.
11. Install the new filter element with its holed end
facing down. Insert the holed end of the filter
element snugly into the groove inside the oil fil-
ter support.
12. Install the air plug to the oil filter case.
Use a new air bleeder plug provided with a new
element.
Tightening
torque
to prevent oil from drip-
from the filter case.
and tap it with a hammer
and the O-ring groove of the oil filter
of the oil filter case with a
1.5 ± 0.6 N·m
(1.1 ± 0.4 ft.lbs.,
0.15 ± 0.06 kgf·m)
to remove
with a new one;