Daher-Socata TBM 900 Pilot's Information Manual page 496

SECTION 8
HANDLING, SERVICING AND MAINTENANCE
3) Remove intermediate seats – refer to Paragraph 1.D.
4) Remove the deflectors (34) maintained with Velcro-type strap.
5) If necessary, remove the cabin central carpet.
C - Cabin comfort (Figure 8.10.3)
1) Remove blanking plugs (32) from their storage bag and install them on holes located forward the
large door - see Figure 8.10.3 Detail B.
2) Remove blanking device assy (33) from the hot air outlet, located forward the large door, and store it
into storage bag - see Figure 8.10.3 Detail A.
3) Remove blanking plugs (31) located in line with card table - see Figure 8.10.3 Detail D, and install
them on holes located in line with R.H. front side window - see Figure 8.10.3 Detail C.
D - Installation of cabinet
E - Installation of intermediate seats
1) Install intermediate seats – refer to Paragraph 1 G.
2) If removed, install the baggage compartment partition net.
3) If removed, install cabin central carpet.
F - Installation of rear seats (Figure 8.10.1)
1) Make sure the work area is clean and free from debris.
2) Clear the carpet from seat area to facilitate moving in rails.
3) Check that knobs (8) maintain locks (3) in up position.
4) Position the seat, fold it forward, refer to Detail B, and insert pads (4) into rail (5) apertures.
5) Move the seat so that locks (3) are in front of the color mark made on rail bottom.
6) Pull up and hold L.H. and R.H. rings (2) and turn knobs (8) by 90° in order to insert locks (3) into rail (5)
apertures.
7) Make sure the seat is correctly locked on rails (5).
8) Tilt seat forward, hold it and slip strap (9) around the locking control hinge pin. Screw quick links (7).
9) Tilt the seat rearward and lock it using seat tilting handle (1).
10) Fold up the backrest and lock it using backrest tilting handle (6).
11) Slide properly the carpet under the seat.
12) Remove protective covers.
Page 8.10.4
This operation must be carried out by a service center.
PILOT'S OPERATING HANDBOOK
NOTE
Edition 0 -- October 31, 2013
Rev. 1