Landing Gear; Oxygen - Daher-Socata TBM 900 Pilot's Information Manual

SECTION 8
PILOT'S OPERATING HANDBOOK
HANDLING, SERVICING AND MAINTENANCE

LANDING GEAR

Nose gear tire :
5.00-5 10 PR - Inflation pressure : 98 psi (6.7 bars) *
Main gear tires :
18 5.5 10 PR - Inflating pressure : 135 psi (9.32 bars) *
Nose gear shock absorber :
Fill with hydraulic fluid AIR 3520 B (MIL.H5606E) ; inflate with nitrogen to 87 psi (6 bars).
Main gear shock absorbers :
Fill with hydraulic fluid AIR 3520 B (MIL.H5606E) ; inflate with nitrogen to 160 psi (11 bars).
Hydraulic system :
Check every 100 hours and service with AIR 3520 B (MIL.H5606E) hydraulic fluid.
Brakes :
Service as required with AIR 3520 B (MIL.H5606E) hydraulic fluid.
NOTE
A higher inflation pressure has to be applied to tires and shock absorbers when in very
cold conditions (refer to Chapter 8.9).
(*) Tire inflation pressures are given for an airplane on ground at 21° C.
An ambient temperature change of 3° C produces approximately 1 % pressure change.

OXYGEN

The replenishment device of the oxygen cylinder is installed directly on the cylinder head. It consists of a charging
valve and of a pressure gage graduated from 0 to 2000 PSIG. A chart - see Figure 8.7.4, located on the inside of the
cylinder service door, gives the cylinder charge maximum pressure according to the environment temperature.
Figure 8.7.4 - CHARGE PRESSURE CHART
Edition 0 -- October 31, 2013 Page 8.7.5
Rev. 1