Use Of Cargo Nets - Daher-Socata TBM 900 Pilot's Information Manual

PILOT'S OPERATING HANDBOOK

USE OF CARGO NETS

Net inspection
Before each use, visually inspect net for :
- webbing condition,
- seam condition of tensioning strap,
- metallic part condition.
Installation instructions
Tensioning straps must be installed so that they make a V with a minimum angle of 40° between both strands
attached on the net. The net must be properly tight.
Damage acceptance criteria
If any damage is detected, such as :
- damage or absence of hook, buckle or stud on tensioning strap : strap must mandatorily be discarded and
replaced,
- webbing frayed or cut on less than 30 % of its surface : reduce maximum load by 50 %,
- seam of vertical net tensioning straps damaged on less than 30 % of its length : reduce maximum load
by 50 %,
- seam of tensioning straps attached on the rails damaged on less than 30 % of its length : reduce maximum
load by 50 %,
- beyond 30% damage for above-mentioned cases, defective element must mandatorily be discarded and
replaced,
- netting cut or torn on less than 3.9 in (100 mm) : still serviceable, no impact,
- netting cut or torn on more than 3.9 in (100 mm) : do not carry small objects which dimensions are smaller
than 4.9 x 4.9 x 4.9 in (125 x 125 x 125 mm)
Edition 0 -- October 31, 2013
Rev. 1
SECTION 7
DESCRIPTION
Page 7.3.29