Daher-Socata TBM 900 Pilot's Information Manual page 495

PILOT'S OPERATING HANDBOOK
2) Install intermediate seats.
If seats are installed facing flight direction (frontwards), the L.H. seat must be installed on
the right and the R.H. seat on the left in order to have the armrest on aisle side.
a) Pull backrest bottom upholstery (25) to remove it.
b) Clear the carpet from seat area to facilitate moving in rails.
c) Position the seat and put lock (22) near the color mark (37) made on rail bottom on aisle side.
d) Pull up locking handle (21), insert pads (23) into rail (24) apertures and then, move the seat so
that lock (22) is in front of the color mark (37).
e) Release locking handle (21) to lock the seat.
WARNING : VERIFY THAT LOCK (22) AND ALL PADS (23) ARE ENGAGED AND LOCKED
f) Install backrest bottom upholstery (25).
Adjust it properly; make sure not to obstruct deflector (34) outlet.
g) Slide properly the carpet under the seat.
h) Remove protective covers.
H - Final operations
1) If removed, install cabin central carpet suited to the intended use.
2) If necessary, remove the baggage compartment partition net and install the small or large cargo net
(refer to Section 7).
3) Make sure the work area is clean and free from debris.
4) Determine weight and balance (refer to Section 6).
2 - CONVERSION OF 4-SEAT ACCOMMODATION INTO 6-SEAT ACCOMMODATION (Figures 8.10.1,
8.10.2, 8.10.3 and 8.10.4)
A - Tools and consumable materials
- Seat protective covers
B - Preparation
1) Make sure the "SOURCE" selector is set to "OFF" and the crash lever is down.
2) If installed, remove the cargo net.
Edition 0 -- October 31, 2013
Rev. 1
The color mark (37) in the rail is aligned with red marks (36).
INTO RAILS, TRYING TO MOVE SEAT FORWARD AND BACKWARD.
Slide properly the carpet under doorstep.
HANDLING, SERVICING AND MAINTENANCE
NOTE
NOTE
NOTE
NOTE
SECTION 8
Page 8.10.3