MV Agusta F4 BRUTALE 750 ORO Workshop Manual page 356

Before reassembling the rear brake disc, check the
condition of the four pins and four special nuts.
Proceed with tightening of the nuts.
The screws must be assembled with the
nuts screwed in lightly and brought into con-
tact with the disc surface.
After this operation, tighten the four nuts in
a cross-like mode.
Rear brake disc nut torque pressure: 18÷20
N•m.
Apply Loctite 270
Conclude the reassembly operations of the various
components by following the procedures previously
described in these paragraphs in reverse order.
H
Brakes
18÷20 N•m
- 30 -